|
| |
TM 10-4930-241-13
Section II. SERVICE UPON RECEIPT
4-4. SITING.
a.
Transport. The AFSSP is designed to be packaged and transported by truck or aircraft. Secure AFSSP
components to the transport vehicle before movement.
b.
Site Selection. When selecting a site for installation of the fuel system, consider the overall operating
area.
Siting must include access to the aircraft, tanker and rail staging areas and provide adequate
space to set up
the system, and space for movement of support vehicles. Site should be level, free of
overhead
obstructions
and provide good drainage to prevent water damage. Avoid low areas where fuel
vapors can collect. To
prevent a hazard to personnel and equipment, site must be located downhill or
downstream
from
other
installations. For additional siting information, refer to FM 10-68 and FM10-69.
4-5. SHELTER REQUIREMENTS.
The fuel system does not require special sheltering during normal operation. Store unused fuel system
components in a storage van or shelter to prevent damage and minimize routine maintenance.
4-6. CHECKING UNPACKED EQUIPMENT.
a.
Unpacking Fuel System Equipment. Components of the AFSSP are packaged and shipped in cardboard boxes
or crates. Where possible, save packaging materials for reuse. Use ca e when unpacking to
prevent
damage to fragile components. This manual addresses installation and use of all components,
but you may not
need to unpack all of them to perform your mission.
Refer to the applicable technical manuals for unpacking instructions for the following equipment:
600 GPM Pump Assembly ....................................................................................... TM 10-4320-342-24
Closed Circuit Refueling (CCR) Nozzle and Gravity Fill Adapter ..................... TM 10-4930-243-13&P
Single Point Refueling Nozzle (D1) .................................................................... TM 10-4930-242-13&P
Collapsible Fabric Tank, Low Temperature .............................................................. TM 10-543231-12
200 Gpm Filter-Separator ........................................................................................ TM 10-4330-236-13
4-3
|
