|
| |
TM 10-4930-240-13
2-22. OPERATION IN SANDY OR DUSTY AREAS-cont.
(5) Do not operate 200 GPM pump during dust storms or in blowing sand.
(6) Refer to TM 10-4320-342-10 for additional precautions to follow when operating the 200 GPM pump
in dusty or sandy conditions.
(7) Refer to TM 10-4330-236-13 for additional precautions to follow when operating the 200 GPM filter
separator in dusty or sandy conditions.
2-23. OPERATION IN SALT WATER AREAS.
Observe the following precautions when operating the AFARE in saltwater areas.
WARNINGS
Do not operate fuel system in area of tents or shelters. Inhalation of
petroleum fumes and vapors will result in serious illness or death.
Dry cleaning solvent, P-D-680, Type III, is potentially dangerous to
personnel and equipment. Eye and skin protection is required. Avoid
repeated and prolonged skin contact. Wash hands immediately after
exposure. Do not use near open flame or excessive heat. Use only m
areas with good ventilation.
(1) Operation in salt water areas accelerates corrosion on bare metal surfaces. Following operation in
salt water areas, rinse components with cleaning solvent to remove salt spray and/or deposits. Do
not allow salt water to remain on aluminum components.
(2) Refer to applicable TM 10-4320-342-10 for additional precautions to follow when operating the 200
GPM pump in saltwater areas.
(3) Refer to applicable TM 10-4330-236-13 for additional precautions to follow when operating the 200
GPM filter separator in saltwater areas.
2-72
|
