|
| |
TM 10-4930-240-13
2-15. ASSEMBLY AND PREPARATION FOR USE - cont.
i. Fuel System Assembly. Refer to figure 2-16.
(1) Loosen straps and remove all Items from fuel hose carriers and component carriers.
CAUTION
To prevent contamination of fuel system components, keep dirt, ice and snow from
entering open couplings during assembly.
NOTES
· This manual covers installation of a typical AFARE system. You may need to
adjust the number of components used, and their position. In the system, to
meet your mission requirements. Additional hoses, couplings, adapters and
elbows are supplied with the AFARE as accessories.
Refer to para 2-15h for connection of quick disconnect couplings.
(2) Connect coupler (1) (4 in F x 3 in M) to 500 gallon drum (2).
(3) Connect coupler (3) (4 In F x 3 in M) to 500 gallon drum (4).
(4) Connect coupler (5) (4 In F x 3 in M) to 500 gallon drum (6).
(5) Connect tee (7) to coupler (3) (4 in. F x 3 in. M).
(6) Connect tee (8) to coupler (5) (4 in F x 3 in M).
(7) Connect 3 in. x 10 ft. suction hose (9) between coupler (1) and tee (7).
(8) Connect 3 in. x 10 ft. suction hose (10) between tee (7) and tee (8).
(9) Connect 3 in. x 10 ft. suction hose (11) to tee (8).
(10) Connect tee (12) (3 in. M x 3 in. F x 3 in. F) to 3 in. x 10 ft. suction hose (11).
(11) Connect 3 in. x 10 ft. suction hose (13) between tee (12) and fueling manifold assembly (14).
(12) Connect 3 in. x 10 ft. suction hose (15) between fueling manifold assembly (14) and suction
coupling on 200 GPM pump (16).
(13) Connect 3 in. male x 2 in. female reducer (17) to discharge coupling on 200 GPM pump (16).
(14) Connect 3 in. x 10 ft. discharge hose (18) to reducer (17).
(15) Connect 3-inch manifold (19) (3 in. M x 3 in. M x 3 in. F) and valve section (20) to 3 in. x 10 ft
discharge hose (18).
(16) Connect 3 in. x 10 ft. discharge hose (21) between valve section (20) and filter separator (22).
2-43
|
