|
| |
TM 10-4930-240-13
2-15. ASSEMBLY AND PREPARATION FOR USE - cont.
e. Install Deflector. Refer to figure 2-12.
NOTE
Deflector components are kept in the storage box.
(1) Lower locator arms (1) on lower frame (2) to unlock position.
(2) Center lower frame (2) over exhaust extension (3) on 200 GPM pump.
(3) Position brace (4) on lower frame (2) and install pin (5).
(4) Aline other end of brace (4) with mount (6) on 200 GPM pump and install pin (7).
(5) Repeat steps (3) and (4) for other brace (8).
(6) When lower frame (2) is correctly positioned, raise both locator arms (1) to lock position.
(7) Position upper frame (9) and attach deflector (10) on lower frame (2).
(8) Allne mounting holes in upper frame (9) with holes In lower frame (2), then secure in place with
four pins (11).
f. Install Air Ducts. Refer to figure 2-13.
NOTE
Air ducts, couplers and clamps are kept in the storage box
(1) Position clamp (2) over end of air duct (3).
(2) Slide end of air duct (3) onto deflector (1), then tighten clamp (2).
(3) Position clamp (4) on end of air duct (3).
(4) Position clamp (6) on end of air duct (7).
(5) Slide ends of air ducts (3 and 7) onto coupler (5).
(6) Tighten clamps (4 and 6).
(7) Position clamp (8) on end of air duct (7).
(8) Position clamp (10) on end of air duct (11).
(9) Slide ends of air ducts (7 and 11) onto coupler (9).
(10) Tighten clamps (8 and 10).
2-37
|
