|
| |
TM 10-4930-240-13
4-26. EXHAUST DEFLECTOR ASSEMBLY REPAIR- cont.
c.
Repair. Replace damaged or defective components.
d.
Assembly. Refer to figure 4-17.
(1) Install two nuts (20) and bolts (19) on locators (18).
(2) Position two locators (18) in lower frame (21) and install nuts (17).
(3) Install two nuts (16), screws (15) and nuts (14) in lower frame (21).
(4) Install two rivets (11) and pins (12) in two angle braces (13).
(5) Install four pins (10) and rivets (9) in lower frame (21).
(6) Position deflector (3) on upper frame (8) and install eight screws (7), lockwashers (6) andnuts (5).
(7) Slide vent (4) onto deflector (3).
(8) Install pin (21 on deflector (3) with rivet (1).
4-27. SUCTION HOSE ASSEMBLY (3 IN. X 10 FT) REPAIR.
Refer to para 4-12 for repair of the 31n x 10 ft suction hose assembly.
4-28. FUELING MANIFOLD ASSEMBLY REPAIR.
Repair of the fueling manifold skid assembly is accomplished by replacing and/or repairing components that
make up the assembly. Refer to the following paragraphs to repair components of the fueling manifold skid
assembly.
Procedure
Para.
Cover Assembly Repair ..........................................................................
4-29
Fueling Manifold Assembly Repair..........................................................
4-30
Skid Assembly Repair.............................................................................
4-31
4-29. COVER ASSEMBLY (FUEL MANIFOLD) REPAIR.
Refer to para 4-17 for repair of cover assembly.
4-52
|
