|
| |
TM10-4930-239-12&P
4-12. HOSE ASSEMBLIES.
This Task Covers:
Repair
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Clamping Tool (Appendix C, Item 37)
Clamping Tool (Appendix C, Item 38)
Material's Required
Brush, Medium Bristle (Appendix E, Item 2)
Solvent, Dry Cleaning (Appendix E, Item 3)
Cloth, Lint-Free (Appendix E, Item 1)
Strapping (Appendix C, Item 42)
Strapping (Appendix C, Item 43)
Strapping (Appendix C, Item 45)
Strapping (Appendix C, Item 46)
Equipment Condition
Hose assembly removed from fuel system.
Repair. (Refer to Figure 4-1.)
NOTE
Repair is limited to replacement of parts found defective during inspection.
a. Disassembly.
(1) Cut hose clamps (1) and remove clamps from hose assembly.
(2) Remove female coupling half (2) and male coupling half (3) from hose assembly.
(3) Remove quick disconnect plug (4) from female coupling h alf (2).
(4) Remove quick disconnect cap (5) from male coupling half (3).
(5) Remove gaskets (6) and (7) from female coupling half (2) and from quick disconnect cap (5).
b. Cleaning.
(1) Remove ail build up of dirt, oil, and debris from all mating surfaces and clamping areas.
4-6
|
