|
| |
TM 10-4930-232-12&P
CHAPTER 2
OPERATING INSTRUCTIONS
Page
OVERVIEW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Section I.
Description and Use of Operator’s Controls and lndicators . . . . . . . . . . . . . . . . . . . . 2-1
Section II.
Operator Preventive Maintenance Checks and Services(PMCS) . . . . . . . . . . . . . . . 2-1
Section III.
Operation Under Usual Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-4
Section IV.
Operation Under Unusual Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-10
OVERVIEW
Chapter 2 contains references to equipment manuals for description of component controls and indicators.
Operator Preventive Maintenance Checks and Services (PMCS) is presented in a tabular format. Procedures for
operating the fuel system under usual and unusual conditions are given. For operation of collapsible tanks,
pumps and filter/separators, refer to the designated components manual.
Section II DESCRIPTION AND USE OF OPERATOR’S CONTROLS AND INDICATORS
Paragraph
Page
2-1
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-1
2-1. General. The operator controls and indicators for the system components, such as tanks, pumps and
filter/separators, are covered in the components manuals (refer to Appendix A). There are no operator controls
and indicators for the remainder of the system, which consists of hose assemblies, valves, tees, wyes, and fittings.
The valve handle controls are self-indicating.
Section II. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
Paragraph
Page
2-2
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-1
2-3
PMCS Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-2
2-4
Special Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-2
2-2. General. Preventive maintenance is the responsibility of the using organization. The services will be
performed by the operator in accordance with Table 2-1 and the following:
a.
Before you operate. Always keep in mind the CAUTIONS AND WARNINGS. Perform your “BEFORE” (B)
PMCS.
b. While you operate. Always keep in mind the CAUTIONS AND WARNINGS. Perform your “DURING” (D)
PMCS.
c.
After you operate. Be sure to perform your “AFTER” (A) PMCS.
2-1
|
