|
| |
TM 10-4930-229-12&P
4-15. Tee Fitting Assembly.
This task covers:
a. Repair
b. Replace
INITIAL SETUP
Tools:
Tool Kit, General Mechanic’s, Item 1, Section III
Appendix B
Materials/Parts:
General Safety Instructions:
WARNING
Cleaning Solvent, Item 4, Appendix E
Rags, Wiping, Item 5, Appendix E
Sealing Compound, Item 3, Appendix E
Gasket
Equipment Conditions:
FARE shutdown, para 2-12.
Inspected, para. 3-7
. Do not smoke or use an open flame in the
vicinity of the FARE, failure to comply may
result in personnel injury.
. Drain any fuel into suitable container. Clean up
any fuel spills to prevent fire or environmental
hazard.
WARNING
Cleaning solvent, Federal Specification PD-660, is toxic and flammable.
Use only in a well-ventilated area. Avoid prolonged breathing of fumes.
Keep solvent away from flames. Do not use in excessive amounts.
Avoid skin contact.
(b) Clean tee assembly with solvent and allow to dry.
(c) Remove two dust plugs (1) and dust cap (2).
(d) Remove gaskets (3). Discard gaskets.
(e) Remove female coupling halves (4) and male coupling half (5) from tee (6). Remove sealing
compound from threads.
(f) Inspect tee assembly for damaged dust plugs or dust cap.
(g) Inspect tee assembly for damaged camlock levers.
(h) Replace any parts found to be defective with new parts from stock.
a. Repair. (figure 4-7)
(1) Disassembly.
(a) Inspect tee fitting assembly for damaged or missing components.
4-21
|
