|
| |
TM10-4330-235-13&P
(4)
Procedure. This column gives the procedure you must do to check or service the item listed in
the Check/Service column to know if the equipment is ready or available for its intended mission
or for operation. You must do the procedure at the time stated in the interval column.
(5)
Not Fully Mission Capable If:.
Information in this column tells you what faults will keep your
equipment from being capable of performing its primary mission. If you make check and service
procedures that show faults listed in this column, do not operate the equipment. Follow standard
operating procedure for maintaining the equipment or reporting equipment failure.
f. Other Table Entries. Be sure to observe all special information and notes that appear in your table.
Table 4-1. Preventive Maintenance Checks and Services
ITEM
INTERVAL
ITEM TO BE
PROCEDURE
NOT FULLY MISSION
NO.
CHECKED OR
CAPABLE IF:
SERVICED
1
QUARTERLY
Cover Bolts
Check for tightness and torque
as required.
2
QUARTERLY
Diff. Pressure Gage
Check for damage.
Gage is damaged.
3
QUARTERLY
Sight Gage
Check body for cracks and ball Gage is damaged.
float for damage.
4
QUARTERLY
Ground Rod
Check for missing or damaged Ground rod is missing
sections.
or damaged.
5
QUARTERLY
Tank and Frame
Inspect for damage or signs of
rust. Clean and repaint.
Section IV. Troubleshooting
4-5. INTRODUCTION
a.
Table 4-2 lists common malfunctions that you may find with your equipment. Perform the tests,
inspections, and corrective actions in the order they appear in the table.
b.
This table cannot list all the malfunctions that may occur, all the tests and inspections needed to
find the fault, or all the corrective actions needed to correct the fault. If the equipment malfunction
is not listed or actions listed do not correct the fault, notify your supervisor.
4-2
|
