|
| |
TM 10-4320-351-14
WARNING
Serious injury could occur if heavy equipment is moved/lifted without sufficient
personnel to do the job. Always use four personnel to move or relocate the
modules and kits. Use proper physical lifting procedures or use a suitable lifting
device or dolly. Wear safety shoes, gloves and other suitable protective clothing.
b. Remove engine module from pump-engine module. Refer to figure 2-4.
(1) Unclamp exhaust pipe (1) from exhaust manifold (2).
(2) Disconnect pumpage overtemperature cable (3) at engine module connection panel (4). Install dust caps on
connectors. Wrap free end of cable around fuel transfer pump outlet (5).
(3) Disconnect fuel supply line (6) and fuel return line (7) at engine module. Connect free ends of lines
together.
(4) Unlatch (8) engine module (9) from pump-engine frame (10) and slide engine module out of frame.
c. Position pump module 6-8 feet (1.8-2.4 m) from drums with the pump inlet manifold facing drum outlets.
d. Install engine module in pump-engine module. Refer to figure 2-4.
(1) Slide engine module into pump-engine module, PTO end first. If flex coupling will not engage it may be
necessary to rotate the flex portion slightly to align with the engine adapter.
(2) Latch (8) engine module to pump-engine frame.
(3) Clamp exhaust pipe (1) to exhaust manifold (2).
(4) Connect pumpage overtemperature cable at engine module connection panel connector 1A1J3 (4). Couple
together adjacent dust caps.
(5) Connect fuel supply line (6) and fuel return line (7) at engine module.
(6) Check that throttle control is at max position (fully right). Refer to figure 2-5.
e. Verify/install thermal blankets on muffler and exhaust line.
f. Position the accessory module between the pump-engine module and the filtration module as shown in figure
2-3 so operator has a clear view and easy access to all system components.
g. Drive a grounding rod near the pump-engine module and connect pump-engine module grounding cable and
accessory module grounding cable to grounding rod.
h. Remove the engine air filter from the storage cabinet in the accessory module, remove cap from engine air
intake and install the filter with clamp handle facing up.
2-13
|
