|
| |
TM 10-4320-351-14
6.3.17 Remove Rear Crankshaft Support. (Refer to figure 6-18)
This task consists of:
a. Removal
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Key, Socket Head Screw, 6 mm
None
(Appendix B, Section III, Item 3)
Flywheel Puller
Equipment Condition:
(Appendix B, Section III, Item 4)
Camshaft and tappets removed (para. 6.3.16)
Remover, Bearing and Bushing
(Appendix B, Section III, Item 6)
a.
Remove the ten socket head cap screws (1) from engine rear support (2).
b.
Using flywheel puller and two of the rear support mounting screws, remove engine rear support (2) and O-ring (3).
Discard O-ring (3).
c.
Remove rear engine oil seal (4). Discard seal (4).
d.
Using bushing extractor tool, remove engine rear main bearing (5) from engine rear support. Discard bearing (5).
Figure 6-18. Rear Crankshaft Support Removal
6-30
|
