|
| |
TM 10-4320-351-14
6.3.3 Remove Flywheel/Alternator Rotor and Stator. (Refer to figure 6-4.)
This task consists of:
a. Removal
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Socket, 1-5/8 ", 1/2" Drive
None
(Appendix B, Section III, Item 3)
Flywheel Puller
(Appendix B, Section III, Item 4)
Key, Socket Head Screw, 5 mm
(Appendix B, Section III, Item 3)
Equipment Condition:
Key, Socket Head Screw, 4 mm
Engine removed from engine module
(Appendix B, Section III, Item 3)
(para. 6.2)
Key, Socket Head Screw, 6 mm
Engine oil drained
(Appendix B, Section III, Item 3)
(Table 4-1)
Handle, Socket Wrench, Ratchet, 1/2" Drive
(Appendix B, Section III, Item 3)
Pliers, Vise Grip
(Appendix B, Section III, Item 3)
Adapter, Socket, 12 " to 3A/4
(Appendix B, Section III, Item 3)
a.
Hold/lock flywheel (1) in place.
b.
Remove pulley wheel nut (2), flat washer (3), pulley (4), roll pin (5), spacer (6), and net (7).
CAUTION
Do not allow flywheel to drop when removing from shaft.
c.
Using a flywheel puller with four jack screws, remove flywheel (1) and tab (8).
d.
Remove the five socket head cap screws (9) attaching the alternator rotor (10) to flywheel. Remove rotor (10).
e.
Remove socket head screw (11) and washer (12) and outboard clamp (13).
f.
Remove four socket head cap screws (14) attaching the alternator stator (15) to the timing cover. Remove stator
(15).
g.
Remove socket head screw (16), washer (17) and wire clamp (18) under stator.
6-10
|
