|
| |
TM 10-4320-351-14
5.7.5 Replace Capacitor C1. (Refer to figure 5-14.)
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Screwdriver, Cross Tip, #2
Tags, Electrical (Appendix F, Section II, Item 16)
(Appendix B, Section III, Item 3)
Wrench, Socket, 1/4", 1/4" square drive
(Appendix B, Section III, Item 3)
Handle, Socket Wrench (Nutdriver Type)
(Appendix B, Section III, Item 3)
General Safety Requirements:
Equipment Condition:
Accessory module removed from system.
(para. 2.9)
a.
Removal.
(1)
Remove the twenty-four screws (1) and flat washers (2) that secure the control panel (3) to the control box.
(2)
Lift the control panel (3) from the control box and set on edge convenient to capacitor C1 (4).
(3)
Remove screw (5), washers (6), and nut (7) attaching capacitor C1 (4) to the "L" bracket (8). Retain
mounting hardware.
(4)
Remove clamp (9) from capacitor C1 (4).
(5)
Tag and remove leads (10) from capacitor C1 (4).
b.
Installation.
(1)
Install leads on capacitor C1 (4) as tagged. Remove tags.
(2)
Position clamp (9) around center of capacitor C1 (4).
(3)
Attach capacitor C1 (4) to "L" bracket (8) using screw (5), washers (6) and nut (7).
(4)
Install control panel (3) in control box using twenty-four screws (1) and flat washers (2).
5-35
|
