|
| |
TM 10-4320-348-14
b.
Assembly of Equipment. The pumping assembly requires no further assembly for use other than hose
connections and accessory connections needed for local setup and operation. (See para. 2.5).
Refer to Figure 4-1.
(1)
The pump unit should be positioned on a level surface near the source of fuel being pumped.
(2)
Drive ground rod (1) into earth. Secure one end of grounding cable (2) to pump ground connection (3).
Secure other end of grounding cable to ground rod (1). Make sure grounding cable makes metal-to- metal
contact with frame and rod.
4.8 PRELIMINARY SERVICING AND ADJUSTING OF EQUIPMENT. After the pumping unit has been assembled and
set up, the following steps must be performed before attempting to start the engine:
WARNING
Death or serious injury could occur if fuel is not handled carefully. Use in a well-ventilated area
away from open flame, arching equipment, ignition sources, heaters, or excessive heat. Engines
must be turned off and cool before refueling. Use proper refueling procedures and equipment to
avoid spillage. Do not run engines near open fuel containers. Always store fuel in proper, marked
containers. DO NOT SMOKE.
Figure 4-1. Ground Rod and Auxiliary Fuel Line Installation.
4-4
|
