|
| |
TM 10-4320-348-14
2.9 PREPARATION FOR MOVEMENT. (Refer to Figure 2-8.)
a.
Disconnect suction hose from source.
b.
Start pump unit to dispense remaining fuel into a suitable container. (See para. 2.7)
c.
Shut down pump unit. (See para. 2.7)
d.
Remove suction hose from pump suction connection (1); cap and plug as necessary.
e.
Remove discharge hose from pump discharge connection (2). Disconnect dispensing nozzle and drain fuel into a
suitable container; cap and plug nozzle and container as necessary.
f.
Open pump fluid drain cock (3) and allow pump to drain. Close pump fluid drain cock.
g.
Disconnect all other Y fittings and other accessory items and pack into storage chests in accordance with
information plates on chests.
h.
Secure storage chest lids to storage chests as follows: (Refer to Figure 2-3.)
(1)
Place storage chest lid (9) onto top of storage chest (5).
(2)
Place strap (3) over top of storage chest lid (9) and insert loose end of strap into slot (6) of strap ratchet (4).
(3)
Pull end of strap (3) through slot (6) until about 1 inch of strap sticks out of other side of slot.
(4)
While holding end of strap (3) inside slot (6) and holding ratchet assembly (4), crank strap ratchet handle (2)
upward to rotate shaft of ratchet and roll strap (3) around shaft.
CAUTION
Do not over tighten the strap assembly around the storage chest and storage chest lid. Over-
tightening the strap will damage the storage chest assembly.
(5)
Continue to crank strap ratchet handle (2) up and down until strap (3) tightens around storage chest lid (9)
and storage chest (5) to the point where the lid is securely held in place on the chest.
(6)
Engage rubber latches (7) into catches (8) to secure lid (9).
i.
Refer to unit maintenance to remove grounding rod and auxiliary fuel line (if used).
j.
Pumping assembly is now ready for movement.
Figure 2-8. Preparation for Movement
2-29
|
