|
| |
TM 10-4320-348-14
4.34 FRAME HANDLES REPAIR AND REPLACEMENT.
This task covers:
a) Removal
b) Installation
INITIAL SETUP
Tools
Equipment
Tool Kit, General Mechanics
Condition
(Appendix B, Section III, Item 1)
Para
2.9 Pumping Assembly removed from system
Materials/Pans
Nut, Self-locking (Appendix I, Section II, Item 19)
Figure 4-28. Handles and Posts
a.
Removal. (Refer to Figure 4-28)
(1)
Observe and note the location of the two nylon washers (1).
(2)
Remove self-locking nut (2), hex bolt (3), and two nylon washers (1) securing handle (4) to post (5).
(3)
Remove handle (4).
(4)
Remove two hex nuts (6), two hex bolts (7), and four washers (8) securing post (5) and ratchet strap bolt
plate (9) or strap bolt plate (10) to frame (11).
(5)
Remove post (5).
b.
Installation.
(1)
Install ratchet strap bolt plate (9) or strap bolt plate (10) and post (5) to the frame (11) with four washers (8),
two hex bolts (7), and two hex nuts (6).
(2)
Install handle (4) to post (5) with two nylon washers (1). Position nylon washers (1) as noted in removal and
then install hex bolt (3), and hex nut (2).
4-62
|
