|
| |
TM 10-4320-348-14
j.
Front Panel and Mechanical Controls Installation. (Refer to Figure 4-11.)
(1)
Position the sound enclosure front panel assembly (10) on frame (5).
(2)
From the outside of the sound enclosure front panel assembly (10), feed throttle cable (27) into the hole in
the sound enclosure front panel (10).
(Refer to Figure 4-14)
(3)
On the inside of the sound enclosure front panel assembly (1), secure throttle cable mounting (7) with
washer (6) and nut (5).
(4)
Attach cable (4) end to throttle control (2), then secure by tightening cable set screw (3).
(Refer to Figure 4-13)
(5)
Pull recoil starter rope T-handle (2) away from starter case until 2 feet of rope (1) is exposed.
(6)
Grasp rope (1) firmly and pull the knot 6 inches out of T-handle (2). Untie the temporary knot in rope (1).
(7)
Feed rope (1) through sound enclosure front panel grommet (4).
(8)
Feed rope (1) through the hole in T-handle (2). Feed enough rope (1) through T-handle (2) to make a knot.
(9)
Tie a knot in rope (1) and pull it against the hole in T-handle (2). Stuff excess rope into the T-handle (2) slot.
(Refer to Figure 4-11)
(10)
Push oil drain hose (20) onto inside of panel fitting (21) and secure with clamp (19).
(11)
If necessary, slide the sound enclosure front panel (10) inward and from the inside of the panel, install fuel
selection valve (15) into the two front panel holes.
(Refer to Figure 4-12)
(12)
Install adapter (6) onto elbow (7).
(13)
Install compression fitting cap (8) and gasket (9) onto auxiliary fuel input connection.
(14)
Position fuel selection valve information plate (4) against the outside of the sound enclosure front panel (5)
and secure with two screws (3).
(15)
Install fuel selection valve handle (1) and screw (2).
(Refer to Figure 4-11)
(16)
Screw oil filler tube (12) into engine crankcase (16).
(17)
Push volute drain hose (15) onto inside of panel fitting (17) and secure with clamp (14).
(18)
Install Inlet (suction) hose adapter (6) onto threaded pipe nipple (7).
(19)
Secure the sound enclosure front panel assembly (10) to frame (5) with the three nuts (9), and three bolts
(8).
(20)
Install front ratchet strap (4), two post/handle assemblies (3), four washers (2), and four screws (1).
4-39
|
