|
| |
TM 10-4320-348-14
a.
Front Panel and Mechanical Controls Removal. (Refer to Figure 4-11)
(1)
Remove four screws (1), four washers (2), two post/handle assemblies (3), and ratchet strap (4) from frame
(5).
(2)
Remove inlet (suction) hose adapter (6) from threaded pipe nipple (7).
(3)
Remove the three bolts (8), and three nuts (9) securing the sound enclosure front panel assembly (10) to
the frame (5).
(4)
Remove oil dipstick (11) and unscrew oil filler tube (12) from engine crankcase (13).
(5)
Loosen rear clamp (14) and disconnect volute drain hose (15) from volute (16) and fitting (17).
(6)
Remove cock drain (18) from sound enclosure front panel assembly (10).
Figure 4-12. Fuel Selection Valve
(7)
Refer to Figure 4-12. Remove fuel selection valve handle (1) and screw (2).
(8)
Remove two screws (3) securing fuel selection valve and information plate (4) from sound enclosure front
panel assembly (5).
(9)
Refer to Figure 4-11. Loosen clamp (19) and disconnect oil drain hose (20) from inside of panel fitting (21).
(10)
Remove pipe plug (22) from sound enclosure front panel assembly (10).
(11)
Remove two wing nuts (24) and two washers (25) from threaded rod (26). Remove threaded rod (26).
(12)
Pull recoil starter rope T-handle (23) until 2 feet of rope is exposed.
4-34
|
