|
| |
TM 10-4320-348-14
(3)
Installation.
(a)
Secure wire leads to proper toggle switch (12) terminals as noted during removal.
(b)
Position toggle switch (12) in front panel (7) and install locking ring (11) with slot in toggle switch (12)
and hole in front panel (7), star washer (10), and outer nut (9).
e.
Circuit Breakers.
(1)
Inspection. (Refer to Figure 4-10)
Inspect the heater control circuit breakers (13) for damage. Replace if damaged.
(2)
Removal.
(a)
Remove outer nut (14) and lock washer (15) from circuit breaker (13).
(b)
Tag wires and remove circuit breaker (13) from front panel (7).
(3)
Installation.
(a)
Secure wire leads to circuit breaker (13) as noted during removal.
(b)
Position circuit breaker (13) in front panel (7) and secure with lock washer (15) and nut (14).
CAUTION
Wires installed near hot or sharp operating surfaces will result in melted or damaged
wire insulation causing a short circuit.
f.
Wiring Harness.
(1)
Inspection.
Inspect all wires for signs of melted or missing insulation, deterioration, or other damage. Replace if damaged.
(2)
Removal.
(a)
Cut and remove cable ties.
(b)
Tag and remove.
(3)
Installation.
(a)
Cut length(s) of wire as required.
(b)
Strip insulation from each end of new length(s) of wire and secure to tagged locations as required.
(c)
Attach terminals to each end of wires.
4-30
|
