|
| |
TM 10-4320-343-14
SECTION III. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES
4.7 GENERAL.
Figure 4-1 (PMCS Routing Diagram) and Table 4-1 (PMCS Table) have been provided so you can keep your equipment
in good operating condition and ready for its intended mission.
4.7.1 Warnings, Cautions And Notes. Always observe the WARNINGS and CAUTIONS appearing in your PMCS
table. Warnings and cautions appear before applicable procedures. You must observe these WARNINGS and
CAUTIONS to prevent serious injury to yourself and others and to prevent your equipment from being damaged.
4.7.2 Explanation Of Table Entries.
4.7.2.1 Item No Column.
Numbers in this column are for reference. When completing DA Form 2404 (Equipment Inspection and Maintenance
Worksheet), include the item number for the check/service indicating a fault. Item numbers also appear in the order in
which you must do checks and services on the routing diagram, Figure 4-1.
4.7.2.2 Interval Column. This column tells you when you must do the procedure in the procedure column.
4.7.2.3 Item to be Inspected Column.
This column provides the item to be checked or serviced.
4.7.2.4 Procedure Column This column gives the procedure you must perform to check or service the item listed in the
Check/Service column to know if the equipment is ready or available for its intended mission or for operation. You must
do the procedure at the time stated in the interval column.
2.2.2.5 Not Fully Mission Capable If: Column. Information in this column tells you what faults will keep your equipment
from performing its mission. If there is an entry in this column do not operate the equipment for its intended purpose until
the fault has been corrected. Follow standard operating procedures for maintaining the equipment and reporting
equipment failure,
4.7.3 Other Table Entries. Be sure to observe all special information and notes that appear in your table.
Table 4-1. Preventive Maintenance Checks and Services for the 350 GPM Pumping Assembly.
Item
Item to
Not Fully Mission
No.
Interval
be Inspected
Procedure
Capable if:
NOTE
Change oil and oil filter in accordance with LO 10-4320-226-12.
1
200 Hours
OIL FILTER
Change oil and replace oil filter.
2
500 Hours
FUEL FILTER
Replace fuel filter. (Paragraph 4.10.18)
3
Quarterly
SPARK ARRESTOR
Remove and service spark arrestor.
Spark arrestor is
(Paragraph 4.9.1)
damaged or
missing.
4-5
|
