|
| |
TM 10-4320-343-14
Open vent valve (figure 2-5,
1) and ensure that all suction valves (2) and
discharge valves (3) are closed.
DO not smoke or use open flames around fuel.
Ensure container is
used to catch fuel and fuel is disposed of properly.
Failure to
obey this warning may result in personnel injury or death.
Do not operate pump before replacing priming port cap.
Failure to
replace priming port cap and locking securely may result in personal
i n j u r y.
Check pump fuel level by carefully opening camlock levers on priming port
cap (4) and raising port cap slightly to see if fuel is discharged from
priming port.
If fuel is discharged, quickly install priming port cap and
place camlock levers in locked position.
If fuel is not discharged, remove
port cap and add clean fuel of the type to be pumped,
until fuel level reaches
the top of the priming port.
Install priming port cap (4) and place camlock levers in locked position.
Push and raise throttle control (5) from detent latch, releasing it to the
2.4 INITIAL ADJUSTMENTS, CHECKS, AND SELF TEST.
Perform all BEFORE PMCS prior to operating equipment.
2.5 OPERATING PROCEDURES.
The technical manual (TM) reference on instruction plate should refer to
TM 10-4320-343-14
instead
of
TM
5-4320-226-14.
Operating procedures for the 350 GPM Pumping Assembly are provided in
paragraphs 2.5.1 through 2.5.2.
In addition, an instruction plate is provided o n
the lid of the Control Panel.
2.5.1 Starting and Shutdown for Non-regulated Pumps.
Starting and shutdown procedures for
nonregulated 350 GPM Pumping Assemblies are provided in the following paragraphs:
2.5.1.1 Starting for Non-regulated Models.
Perform the following procedures
equipment:
To prevent rolling or sliding, do not work on equipment that
not securely stabilized.
Ensure both wheels are secure.
Failure to obey this warning may result in serious personal
i n j u r y .
to start the
i s
a.
b.
c .
d.
e .
f .
i d l e p o s i t i o n.
When outside temperature is below +10° F (-12° C) refer to
operation of cold start system.
Open Control Panel as follows:
(1) Turn the two fasteners on Control Panel counterclockwise
r e l e a s e.
paragraph 2-8 for
until fasteners
(2) Raise Control Panel cover until retaining holes in two brackets mounted on
top of Control Panel align with retaining hole in bracket mounted on cover.
2-17
WARNING
|
