|
| |
TM 10-4320-343-14
6.6.4 Engine Maintenance.
(continued)
m.
Remove cylinders (figure 6-9, 1) and shims (2).
n.
carefully remove camshaft (3), washer (4) and. valve tappets (5).
0.
Remove flywheel assembly as follows:
(1) Remove eight bolts (6), washers (7), and rear end cover (8).
(3) Press seal (9) out of rear end cover (8).
(3) Remove bolts (10) and flywheel (11),
if ring gear (12) needs to be
replaced,
cut through it with a hard chisel and remove it.
Mark connecting rod caps and corresponding
rods.
p .
Remove connecting rod bolts (figure 6-10,
1) and connecting rod caps (2).
q.
Remove pistons (3).
Identify main bearing caps, mark for location.
r .
Remove bolts (4), washers (5), and main bearing caps (6) and (7) .
s .
Remove eight dowel busings (8).
NOTE
Mark bearing halves on back corresponding with crankshaft and bearing
caps.
t .
Remove crankshaft (9), bearing halves (10),
and stop rings (11 and 12).
u.
Remove two plugs (figure 6-11, 1), and washers (2).
v .
Remove plug (3), washer (4), plug (5), nozzle (6), washer (7), and plug (8).
w.
Remove sleeve bearing (9), notched nail (10) and deflector plate (11).
6-24
NOTE
NOTE
|
