|
| |
TM 10-4320-343-14
d.
Remove two thrust pads (8).
e .
Remove two studs (9) from rocker bracket (10).
6.6.3.2 Repair.
Do not use dry cleaning solvent without proper ventilation and clothing.
Do not smoke or use near open flame or excessive heat.
Dry cleaning
solvent is potentially dangerous to personnel and property.
Clean parts
in a well–ventilated area.
Avoid inhalation of solvent fumes.
Wear
goggles and rubber gloves to protect eyes and skin.
Wash exposed skin
thoroughly.
Flash point of solvent is 100°F to 138°F (38°C to 59°C).
Failure to obey this warning may result in personal injury or death.
a.
Clean parts in solvent.
b .
Inspect bushings (3 and 4) for excessive wear.
Replace if defective.
c .
Inspect studs (7 and 9) for damage.
Replace if defective.
d.
Inspect thrust pads (8) for defects.
Replace if defective.
6.6.3.3 Assembly.
a.
I n s t a ll
b .
I n s t a ll
c .
I n s t a l l
Oil holes
obey this
d.
I n s t a ll
e .
I n s t a ll
two studs (9) in rocker bracket (10).
two thrust pad (8).
two studs (7) and lock nuts (6).
in bushing must align with oil holes in rocker arm.
Failure to
warning may cause equipment damage.
press bushing (4) in each rocker arm (5).
two bushings (3), rocker arms (5), washers (2), and nuts (1).
6-18
|
