|
| |
TM 10-4320-343-14
4.13.10.1 Removal.
WARNING
To prevent rolling or sliding, do not work on equipment that is not securely
stabilized. Ensure both wheels are secure. Failure to obey this warning may result
in serious personal injury.
a.
Remove nuts (figure 4-50, 1), washers (2), screws (3), and grommet (4).
b.
Disconnect panel light (5) from TB1-7 and remove panel light (5).
c.
Remove threaded spring plunger (6).
d.
Remove nuts (7), washers (8), screws (9), and spring plunger bracket (10).
4.13.10.2 Repair.
Remove lens cover (11), replace lamp (12) and install lens cover.
4.13.10.3 Installation.
a.
Install spring plunger bracket (10), screws (9), washers (8), and nuts (7).
b.
Install threaded spring plunger (6).
c.
Route wire through opening in control panel and connect wire to TB1-7.
d.
Position panel light (5), and secure with screws (3), washers (2), and nuts (1).
e.
Install grommet (4).
4-94
|
