|
| |
TM 10-4320-343-14
(1)
Wires connected to terminal board of control panel(Figure 4-39.1, 5).
(2)
Wires connected to oil sending unit (Figure 4-40, view A, 1).
(3)
Wires connected to low oil pressure switch (2).
(4)
Wires connected to V-belt contact switch (view C, 4).
(5)
Wires connected to starter solenoid (view E, 5).
(6)
Wires connected to alternator (view D, 6).
(7)
Wires connected to temperature switch(view F, 8).
a.
Remove cable clamps as necessary.
b.
Remove harness assembly (7).
4.12.5.1.2 Repair.
a.
When repair of wiring harness is required, perform the following:
(1)
Remove defective terminal.
(2)
Strip wire approximately 1/8 of an inch back.
(3)
Ensure that no strands of the wire are cut.
(4)
Install terminal lug on wire by crimping terminal lug on wire.
b.
When a defective wire is found, refer to Appendix F to manufacture replacement wire.
4.12.5.1.3 Installation.
a.
Attach wiring harness assembly (7) to engine with clamps and install as follows:
(1)
Connect wires to alternator (view D, 6) and remove tags.
(2)
Connect wires to V-belt contact switch (view C, 4) and remove tags.
(3)
Connect wires to starter (view E, 5) and remove tags.
(4)
Connect wires to low oil pressure switch (view A, 2) and remove tags.
(5)
Connect wires to oil sending unit (1) and remove tags.
(6)
Connect wires to temperature switch(view F, 8) and remove tags.
b.
Connect wires to terminal board of control panel (Figure 4-39.1, sheet 1, view B, 5) and remove tags.
c.
Position control panel cover (3) on control panel (5) and secure with lockwashers(2) and screws (1).
Change 1 4-76.5/(4-76.6 blank)
|
