|
| |
TM 10-4320-343-14
4.12.3 Battery Cable Maintenance.
This task covers: 4.12.3.1 Removal
4 .
12 . 3 . 3 I n s t a l l a t i on
4.12.3.2 Repair
INITIAL SETUP
Tools
General Safety Instructions
General Mechanic’s Tool Kit (appendix B,
To prevent rolling or sliding, do not
Section III, Item 1)
work on equipment that is not securely
s t a b i l i z e d.
Material/Parts
Do not set tools on battery or battery
case.
Grease (appendix E, Section II, Item 5)
Do not work on battery with negative
Equipment Conditions
terminal connected.
Equipment shut down, refer to
Do not work on equipment without
paragraph 2.5.1.2 or 2.5.2.2.
following standard shop safety
precautions.
Battery cover removed, paragraph 3.4.
4.12.3.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
Do not work on battery with negative terminal connected.
Failure to obey these warnings may result in serious personal injury.
a.
Remove two nuts (figure 4-38,
1) washers (2), one wire (3), two bolts (4)
and one wire (5) from two terminals (6).
b.
Remove two nuts (7), washers (8), one wire (9), two bolts (10), and one
wire (11) from two terminals (12).
c .
Remove bolt (13), lockwasher (14), and terminal lug (15) from starter.
d.
Remove nut (16) and terminal lug (17) from starter solenoid.
4.12.3.2 Repair.
Replace damaged or missing parts.
4.12.3.3 Installation.
a.
Install terminal lug (17) and nut (16) to starter solenoid.
b.
Install terminal lug (15), lockwasher (14), and bolt (13).
c .
Install one wire (11), two bolts (10), one wire (9), washer (8), and nuts (7)
to two terminals (12).
d.
Install one wire (5), two bolts (4), one wire (3), two washers (2), and
nuts (1) to two terminals (6).
4-72
|
