|
| |
To prevent rolling or sliding, do not work on equipment that
is not securely stabilized.
Ensure both wheels are secure.
Do not smoke or use open flames around fuel.
Ensure container is
used to catch fuel and fuel is disposed of properly.
Failure to obey these warnings may result in personal injury or
death.
a.
Remove banjo bolt (figure 4-26, 1), washer (2), hose (3) and washer (4).
Place hose (3) out of the way.
b.
Remove banjo bolt (5) and washers (6), and place hose (7) out of the way.
c .
Remove three nuts (8) and lockwashers (9); then carefully remove fuel feed
PUMP (10) and preformed packing (11).
4.10.17.2 Servicing.
a.
Remove bolt (12), washer (13), cover (14), and gasket (15).
b.
Remove strainer (16) from fuel feed pump (10).
c .
Using clean fuel, thoroughly clean strainer (16).
d.
Install strainer (16) in fuel feed pump (10).
e.
Install gasket (15) and cover (14).
f .
Install washer (13) and bolt (12).
4.10.17.3 Installation.
a.
Position new preformed packing (11) and fuel feed pump (10) to injection pump.
b.
Install three washers (9) and nuts (8).
c.
Position hose (7) to fuel feed pump and install washers (6) and banjo
bolt (5).
d.
Position hose (3) to fuel feed pump and install washers (4 and 2) and secure
with banjo bolt (1).
e.
Refer to paragraph 4.10.16.4 and bleed fuel system.
Do not operate equipment in enclosed area unless exhaust gases
are piped to outside and adequate ventilation is provided.
Avoid inhalation of exhaust fumes.
Failure to obey this warning
may result in personal injury or death.
f .
Start engine and check for leaks.
4-54
TM 10-4320-343-10
4.10.17.1 Removal.
|
