|
| |
TM 10-4320-343-14
4.10.13.1 Removal.
WARNING
Do not work on starter assembly with negative battery terminal connected.
To prevent rolling or sliding, do not work on equipment that is not securely
stabilized. Ensure both wheels are secure.
Failure to obey these warnings may result in serious injury.
a.
Remove bolt (1), lockwasher (2), ground wire (14) and negative (-) battery cable (3).
b.
Remove nut (4). Tag and disconnect wire (5).
c.
Remove nut (6) and washer (7).
d.
Tag positive (+) battery cable (8) and wires (9),
e.
On Model 350 PAFN only, remove nut (11) and washer (12). Tag and disconnect wire (13).
f.
Remove remaining two bolts (1) and lockwashers (2) that secure starter (10) to engine.
g.
Carefully separate starter (10) from engine.
4.10.13.1 Installation.
a.
Position starter (10) on engine so that drive gear mates with teeth on flywheel.
b.
Install two lockwashers (2) and bolts (1), leaving bottom bolt (1) to connect negative battery cable (3) and ground
wire (14).
c.
Install wires (9), positive (+) battery cable (8), washer (7), and nut (6). Remove tags.
d.
Install wire (5) and nut (4). Remove tags.
e.
On Model 350 PAFN only, install wire (13) with washer (12 and nut (11). Remove tags.
f.
Install negative (-) battery cable (3), ground wire (14), lockwasher (2), and bolt (1).
g.
Tighten bolt (1).
Change 1 4-39
|
