|
| |
TM 10-4320-343-14
4.10.6 V-Belt Guard Maintenance.
This task covers: 4.10.6.1 Removal
4.10.6.2 Installation
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Tool Kit (appendix B,
Equipment shut down, refer to
Section III, Item 1)
paragraph 2.5.1.2 or 2.5.2.2.
Material/Parts
General Safety Instructions
Lockwashers (TM 10-4320-343-24P)
To prevent rolling or sliding, do not
Washers (TM 10-4320-343-24P)
work on equipment that is not securely
stabilized.
Do not work on equipment without
following standard shop safety
Precautions.
4.10.6.1 Removal.
a.
b.
c.
d.
e.
f .
To prevent rolling or sliding, do not work on equipment that is
not securely stabilized.
Ensure both wheels are secure.
Failure to obey this warning may result in serious personal
injury.
Remove bolt (figure 4-10, 1), washer (2), and spacer (3).
Remove bolt (4), washer (5), lockwashers (6), and spacer (7).
Remove two bolts (8), lockwashers (9), and washers (10).
Remove nut (11), lockwasher (12), spacer (13), washer (14), and bolt (15).
Remove V-belt guard (16).
Engine pulley guard does not come with the original
manufacturer’s V-belt guard.
Remove and retain nuts (17), washers (18), bolts (19), and engine pulley guard
(20).
4.10.6.2 Installation.
a.
b.
c .
d.
e.
f .
g.
4-26
Position engine pulley guard (20) in place on V-belt guard (16).
Install bolts (19), washers (18), and nuts (17) that secure engine pulley
guard (20).
Position V-belt guard (16) in place on engine.
Install
(11).
Install
Install
Install
bolt (15) using washer (14), spacer (13), lockwasher (12), and nut
two washers (10), lockwashers (9), and bolts (8).
spacer (7), washers (5), lockwashers (6), and bolt (4).
spacer (3), washer (2), and bolt (1).
|
