|
| |
TM 10-4320-343-14
4.10.4.3 Cold Start Aid Nozzle Maintenance. (Used on Model 350 PAFN only)
This task covers:
4.10.4.3.1
Removal
4.10.4.3.2
Installation
INITIAL SETUP
Tools
General Safety Instructions
General Mechanic's Tool Kit (Appendix B, Section III,
To prevent rolling or sliding, do not work on equipment
Item 1)
that is not securely stabilized.
Equipment Conditions
Equipment shut down, refer to paragraph 2.5.2.2.
Do not work on equipment without following standard
shop safety precautions.
4.10.4.3.1. Removal. (Refer to Figure 4-7.3)
a.
Remove nut and tubing(1) from reducer(2).
b.
Remove reducer(3) from manifold(4).nozzle (2) from intake manifold (3) of engine.
c.
Remove nozzle(3) from reducer(2).
4.10.4.3.2. Installation. (Refer to Figure 4-7.3)
a.
Install nozzle (3) into reducer(2) and reducer(2) into engine manifold(4).
b.
Install reducer(2) with nozzle(3) into engine manifold.
c.
Connect nut(l) and tubing to reducer(2).
Figure 4-7.3. Starting Aid Nozzle Maintenance (Model 350 PAFN).
4-22.4 Change 1
|
