|
| |
TM 10-4320-343-14
4.10.3.1 Removal.
WARNING
To prevent rolling or sliding, do not work on equipment that is not securely
stabilizes. Ensure both wheels are chocked.
Failure to obey these warnings could result in serious injury.
a.
Tag and disconnect two hoses (1) from reservoir (2).
b.
Remove two nuts (3) and external tooth lockwashers (4).
c.
Remove reservoir (2).
4.10.3.2 Repair.
a.
Disconnect other end of hose from either cold start pump or cold start nozzle.
b.
Manufacture new hose in accordance with Appendix F.
c.
Connect new hose to cold start pump or cold start nozzle.
4.10.3.3 Installation.
a.
Position reservoir (2) in bracket with lid pointed upward.
b.
Install two external tooth lockwashers (4) and thread nuts (3) on reservoir (2).
c.
Tighten two nuts (3).
NOTE
Connect pump hose to inner connection of reservoir.
d.
Connect two hoses (1) to reservoir (2).
Change 1 4-21
|
