|
| |
TM 10-4320-342-24
4-4. STARTER-GENERATOR REPAIR-continued.
e.
ASSEMBLY. Refer to Figure 4-14.
(1)
Position terminal board (4) on stator assembly (12). Place wire terminal (10) on terminal board and install
two flat washers (9), lockwashers (8) and screws (7).
(2)
Place terminal leads (3) over studs B, C and E on terminal board (4).
(3)
Install washers (6) and nuts (5) on terminal board (4) studs B, C and E.
(4)
Install leads (3), washers (2) and nuts (1) on terminal board (4) studs A and D.
Figure 4-14. Terminal Board Installation
4-17
|
