|
| |
TM 10-4320-342-24
4-4. STARTER-GENERATOR REPAIR - continued.
Refer to Figure 4-4.
(10)
Remove drive screws (1), washers (2) and screen (3) from end bell (4).
NOTES
·
A soft face mallet may be used to tap the outside edge of the end bell during
removal, if necessary.
·
To aid in assembly, note position of tooth lockwasher (5) prior to removal.
(11)
Remove eight screws (5), six lockwashers (6), six flat washers (7) and two tooth lockwashers (8). Remove end
bell (4) from stator assembly (9).
(12)
Remove eight screws (10), eight lockwashers (11) and eight flat washers (12) from end bell (13).
(13)
Remove end bell (13) from stator (9) with armature (14) attached.
(14)
Support end bell (13) in an arbor press and press armature (14) out of bearing (15).
(15)
Remove retaining ring (16) and one baffle disc (17) from shaft (18) on armature (14).
(16)
Using a bearing puller, remove bearing (19) from shaft (18) on armature (14). Remove second "J baffle disc (20)
from shaft (18). Discard bearing.
(17)
Remove four screws (21), four lockwashers (22) and bearing retainer (23) from end bell (13).
(18)
Press bearing (15) out of end bell (13). Discard bearing.
(19)
Remove two screws (24), nuts (25), washers (26), plastic washer (27) from end bell (13).
(20)
Remove two spacers (29), washers (28) and brush holder (30) from end bell (13).
(21)
Repeat steps (18) and (19) for three remaining brush holders (30).
4-8
|
