|
| |
TM 10-4320-342-24
3-10.
WINCH REPAIR - continued.
NOTE
To aid in assembly, mark and record location of rods (3) on gear box.
(2)
Remove six screws (1 and 2) and three rods (3) from gearbox (4) and motor (5).
(3)
Separate gearbox (4) and motor (5) from drum (6).
(4)
Remove output shaft (7) from gearbox (4).
(5)
Remove thrust washer (8) from end of drum (6).
(6)
Remove input shaft (9) from coupling (10).
(7)
Loosen setscrew (11), pull off coupling (10) and remove key (12) from shaft of motor (5).
(8)
Remove thrust washer (13) from end of drum (6).
(9)
Remove snap rings (14), spacer (15), thrust plate (16), bearing (17) and brake assembly (18) from inside of drum
(6).
3-6
|
