|
| |
TM 10-4320-342-24
2-43. OIL BOOST PUMPS REPAIR - continued.
(4)
Remove caps (17) and brushes (18).
c. REPAIR. Refer to Figure 2-68.
Repair consists of replacing damaged and/or missing components of the oil boost pumps.
d. ASSEMBLY.
(1)
Install brushes (18) and caps (17) in oil boost pump (4).
NOTE
Install antiseizing tape (teflon tape) on all male threads and wrap tape in direction
of threads. Do not allow teflon tape to extend beyond end of threads.
(2)
Install new preformed packing (16) on strainer (12).
(3)
Install strainer (12) on oil boost pump (4).
(4)
Install elbow (11).
(5)
Install elbow (15).
(6)
Install oil lift check valve (14) and adapter (13).
e. INSTALLATION.
(1)
Position pump (4) on bracket (10) and install bolts (9), washers (8) and nuts (7).
(2)
Connect tubes (5 and 6) to elbows (11 and 15) on oil boost pump (4).
(3)
Connect electrical connector (3) on oil boost pump (4).
(4)
Close doors (1 and 2).
2-165
|
