|
| |
TM 10-4320-342-24
2-30. FUEL SELECTOR VALVE REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanics Tool Kit (App B, Sect III,
200/600 GPM pump assembly removed from
Item 1)
system (Para 2-9, TM 10-4320-342-10)
Material/Parts
Antiseize Tape (App E, Item 6)
a.
REMOVAL. Refer to Figure 2-50.
(1)
Disconnect tubes (1, 2 and 3).
(2)
Loosen set screw (4) and remove handle (5).
(3)
Remove panel nut (6), flatwasher (7) and valve (8) from control panel.
NOTE
Note position of elbows prior to removal.
(4)
Remove elbows (9, 10 and 11) from valve (8).
b.
INSTALLATION.
NOTE
Install antiseize tape (teflon tape) on all male pipe threads and wrap tape in
direction of threads. Do not allow teflon tape to extend beyond end of threads.
(1)
Install elbows (9, 10 and 11) on valve (8) as noted during removal.
(2)
Install valve (8) on control panel and secure with flatwasher (7) and panel nut (6).
(3)
Install handle (5) and tighten set screw (4).
(4)
Connect tubes (1, 2 and 3) to elbows (9, 10 and 11).
2-129
|
