|
| |
TM 10-4320-342-24
2-26. PUMP AND CLUTCH WIRING HARNESS REPAIR.
This task covers:
a. Removal
b. Repair
c. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanics Tool Kit (App B, Sect III,
200/600 GPM pump assembly removed from
Item 1)
system (Para 2-9, TM 10-4320-342-10)
Electrical Connector Kit (App B, Sect III, Item 2)
NOTES
·· This procedure covers the clutch wiring harness for the 200 GPM fuel pump.
Replacement of the clutch wiring harness for the 600 GPM fuel pump is similar.
·· On the 200 GPM Pump, screws are installed on the wiring harness. On the 600
GPM Pump, nuts are installed on the wiring harness.
·· When replacing wiring harness only, the pump and clutch do not have to be
removed.
a.
REMOVAL. Refer to Figure 2-46.
(1)
Remove connector (1) from receptacle (2).
(2)
Remove screws (3), flatwashers (4) and clutch wiring harness (5) from pump and clutch assembly (6).
b.
REPAIR.
(1)
Remove damaged electrical connectors (7).
(2)
Strip 1/4-inch of insulation from wires (8 and 9).
(3)
Crimp electrical connectors (7) onto wires (8 and 9).
c.
INSTALLATION.
(1)
Install clutch wiring harness (5) on pump and clutch (6) with flatwashers (4) and screws (3).
(2)
Install connector (1) on receptacle (2).
2-121
|
