|
| |
TM 10-4320-342-10
2-6. ASSEMBLY AND PREPARATION FOR USE - continued.
NOTE
The ground stud side is the preferred lifting side.
(a)
Guide forklift tongs into forklift guides (4) on the 200/600 GPM Pump (3) and lift.
(b)
Position 200/600 GPM Pump (3) in designated site and lower it to the ground.
(4)
Winch positioning (wheels up or down). Refer to Figure 2-5.
WARNING
Do not touch cold metal parts with bare hands when operating under arctic
conditions. Frostbite could cause permanent injury.
(a)
Lift up on lock (1) and turn winch control handle (2) to freewheeling position.
CAUTION
When extending wire rope, leave a minimum of five wraps on the drum or damage
to equipment could occur.
(b)
Grasp winch hook (3) and pull to object to be connected and connect.
(c)
Lift up on lock (1) and turn winch control handle (2) to the engaged position.
(d)
On door (4) release 13 turn-lock fasteners (5) and open door (4).
CAUTION
When winch is in operation, be careful not to damage door or electrical cord.
Move 200/600 pump slowly.
(e)
Remove winch control box (6) from 200/600 GPM Pump (7) and extend electrical cord (8).
WARNING
Keep a safe distance from wire rope and path of load during operation. Wire rope
failure could cause personnel injury or death.
(f)
On winch control box (6) press retract switch (9) and walk along with the 200/600 GPM Pump (7) to required
position.
(g)
When 200/600 GPM Pump (7) is at required position, release the retract switch (9).
(h)
On winch control box (6) press extend switch (10) and remove hook (3).
(i)
With one person holding hook (3) to keep tension on wire rope and rewind wire rope evenly on winch (11).
Press retract switch (9).
(j)
Place winch control box (6) in 200/600 GPM Pump (7).
(k)
Close door (4) and lock 13 turn-lock fasteners (5).
2-37
|
