|
| |
TM 10-4320-324-14
(15) Press seal (52) into rear end cover (51).
(16) Apply silicone sealer and install rear end cover
(51) using eight flat washers (50) and bolts
(49).
(17) If ring gear (42) has been removed, heat it to a
temperature of 248°F (120°C). Position ring
gear (42), beveled edge against flywheel, on
flywheel (41) and tap it into position so it seats
against shoulder.
(18) Install flywheel (41) with 10 bolts (40). Preload
bolts (77) to 22 lb-ft (30 Nm). Stage 1 angle is
30
. Stage 2 angle is 30°. Total is 60°.
6-25
|
