|
| |
TM 10-4320-324-14
5-14. Injection Pump Replacement (CONT).
CAUTION
Do not drop capscrews or washers into timing cover. A clean shop
cloth placed inside case will catch tools or hardware.
(c)
Turn injection pump nut (19) until one drop every 5 to 8 seconds
appears at the end of the overflow tube, with timing pointer (28)
alined with fuel injection point mark.
(d)
Hold injection pump shaft in this position and tighten screws (11).
(e)
Recheck fuel beginning point by repeating steps (a) through (d).
(16)
Remove overflow pipe (23) and catch container (24).
(17)
Install and tighten fuel line (7).
(18)
Remove hand pump (26) and install inlet fuel line (3) with two new washers (2) and banjo bolt (1).
(19)
Remove plug (25) from overflow port.
(20)
Install new sealing ring (7) and fuel overflow line (6) with new washer (5), and banjo bolt (4).
5-36
|
