|
| |
TM 10-4320-324-14
5-3.
Repair Parts.
Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 10-4320-324-24P, covering
unit, direct support, and general support maintenance (including Depot Maintenance Repair Parts and Special Tools) for
this equipment.
Section II. TROUBLESHOOTING
5-4.
General.
This section contains troubleshooting information for locating and correcting the common malfunctions which may be
encountered during the operation or maintenance of the 350 GPM Pumping Assembly or its components.
5-5.
Troubleshooting. I
To troubleshoot the 350 GPM Pumping Assembly, refer to Table 5-1, Troubleshooting.
a. Each malfunction for an individual component, unit or system is followed by a list of tests or inspections which
will help in determining corrective actions to take. Perform the tests/inspections and corrective actions in the
order listed.
b. This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify the appropriate supervisor.
Table 5-1. Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1
ENGINE ASSEMBLY 1. ENGINE FAILS TO START.
Step 1. Check for loose, broken, frayed or damaged wires between fuel shutdown solenoid, low oil
pressure switch and V-belt switch.
Replace or repair wires as required.
Step 2. Check for broken or frayed wires between alternator and voltage regulator.
Replace or repair wires as required.
5-2
|
