|
| |
TM 10-4320-324-14
NOTE
Do not rotate engine after this operation is complete.
(9)
Remove engine air intake and exhaust manifolds.
(10) Expose area to black (ultraviolet) light. Areas that have been coated with treated oil will fluoresce when
exposed to the black light, giving an indication of preservative coating.
(11)
Install air intake and exhaust manifolds.
(12) Seal engine dipstick, filler cap and breather with tape (PP-T-60).
f.
Rocker Arm Assemblies, Injection Pump, and Push Rods Preservation.
(1) Coat rocker arm and injection pump assemblies with preservative oil, MIL-L-21260.
(2) Spray a small amount of preservative oil, MIL-L-21260, over exposed push rod assemblies.
g.
Drive Belts and Pulleys.
(1) Remove v-belt guard and blower extension.
(2)
Remove cooling blower drive v-belt from blower pulley.
(3)
Relieve tension from alternator v-belt.
(4)
Coat unpainted surfaces of pulleys with a thin film of primer (TT-P-664).
(5)
Install v-belt guard.
(6)
Hang tag (UU-T-81) on cooling air inlet indicating "DRIVE BELTS TENSION RELIEVED -ADJUST PRIOR
TO STARTING ENGINE."
h.
Exhaust System.
(1) Remove spark arrestor.
(2)
Spray interior of tail pipe and spark arrestor with preservative oil, MIL-L-21260.
(3)
Install spark arrestor.
(4)
Seal spark arrestor with tape (PP-T-60).
i.
Tool Box.
(1)
Store all required components, e.g., ground cables, operator's manual, in tool box.
(2) Seal tool box latch with tape (PP-T-60).
4-198
|
