|
| |
TM 10-4320-316-14
4-12. IDENT PLATES REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Bit, Drill, .125 in. dia. (Appendix B, Item 2)
Drill, Hand Portable (Appendix B, Item 2)
Riveter, Blind, Hand (Appendix B, Item 5)
Material's Required
None
Equipment Condition
DED pump assembly shut down and cool.
a. Removal (Refer to Figure 4-1).
NOTE
This procedure describes the replacement of one ident plate. Repeat the procedure as
necessary for all other name plates.
(1)
Drill out rivets (1) that holds ident plate (2) onto unit.
(2)
Remove ident plate (2) from unit.
b.
Installation.
(1)
Place ident plate (2) into position on unit and insert two rivets (1).
(2)
Install two rivets (1) using hand riveter.
4-16
|
