|
| |
TM 10-4320-316-14
6-8. BALANCER SHAFT ASSEMBLY REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, item 1)
Materials Required
Diesel Fuel (Appendix E, Item 6)
Equipment Condition
DED pump assembly shut down and cool.
Crankcase cover removed (see paragraph 6-5).
a. Removal. (Refer to Figure 6-8).
(1) Check the location of the timing marks on all gears.
(2) Remove the balancer shaft (1).
b. Installation.
(1) Insert the balancer shaft assembly (1) into the cylinder block (2).
(2) Refer to Figure 6-9. Make sure the timing marks (1) on the balancer gear (2) and the crank gear (3)
are aligned.
6-16
|
