|
| |
TM10-4320-316-14
b. Installation. (Refer to Figure 6-1).
(1) Install lube oil inlet pipe (6) into crankcase cover (3).
(2) Place a crankcase cover gasket (4) between the surface of the crankcase and the crankcase cover (3).
(3) Apply oil to the lips of oil seal (5).
(4) Apply lubricating oil to crankshaft and camshaft.
(5) Make sure that the oil pump drive gears are properly engaged.
(6) Carefully guide the crankcase cover (3) over the crankshaft and insure that the seal seats properly.
(7) Attach crankcase cover (3) to the cylinder block using 14 bolts (1) plus additional bolt (2) located above the
lube oil strainer.
(8) Refer to Figure 6-3. Tighten bolts in sequence shown and torque to 72-96 in-lb (83-110 kg-cm).
Figure 6-3. Tightening Sequence for Crankcase Cover Bolts.
6-5
|
