|
| |
TM 10-4320-316-14
4-32. EXHAUST SILENCER REPAIR AND REPLACEMENT.
This Task Covers:
a. Removal
b. Inspection
c. Repair.
d. Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Material's Required
Gasket, (Refer to TM10-4320-316-24P)
Equipment Condition
DED pump assembly shut down and cool.
Muffler baffle assembly removed (see paragraph 4-21).
a. Removal (Refer to Figure 4-24).
(1)
Remove two hex head nuts (1) securing the exhaust silencer (2) to studs on the exhaust port of the engine.
(2)
Remove two hex head screws (3) securing the bracket on exhaust silencer (2) to the rear of the engine.
(3)
Lift exhaust silencer (2) and gasket (4) from the studs. Discard gasket.
b. Inspection.
Carefully inspect exhaust silencer (2) for cracks, rust, or pin holes.
c. Repair.
Repair is limited to replacement of defective parts.
d. Installation.
(1)
Position exhaust silencer (2) and new gasket (4) onto the studs and line up holds in bracket with rear mounting
holes on engine.
(2)
Secure exhaust silencer (2) with two hex head nuts (1) onto the studs and two hex head screws
(3) in the mounting holes on engine.
4-72
|
