|
| |
TM 10-4320-316-14
4-31. AIR CLEANER, FILTER ELEMENT, AND AIR INTAKE PIPE REPAIR AND REPLACEMENT.
This Task Covers:
a. Removal
b. Inspection
c. Repair.
d. Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Material's Required
Gasket, (Refer to TM10-4320-316-24P)
Gasket, (Refer to TM10-4320-316-24P)
Equipment Condition
DED pump assembly shut down and cool.
Cooling fan housing removed (see paragraph 4-33).
a. Removal (Refer to Figure 4-23).
(1)
Loosen and remove wing nut (1) and washer (2).
(2)
Remove air cleaner housing cover (3).
(3)
Remove air cleaner element (4).
(4)
Remove three hex nuts (5) securing the air cleaner housing (6).
(5)
Remove air cleaner housing (6). Discard gasket (7).
(6)
Remove hex bolt (8) and air intake pipe (9) and air intake gasket (10). Discard gasket (10).
b. Inspection.
(1) Check that air cleaner housing (6) and cover (3) are free from dirt.
(2) Check air cleaner housing (6) and cover (3) for damage. Replace if necessary.
c. Repair.
Repair is limited to replacement of defective parts.
d. Installation.
CAUTION
Never run the engine without the air cleaner element. Rapid engine wear may
result.
(1) Place new gasket (10) in place, position air intake bend (9), and secure with hex bolt (8).
(2) Place new gasket (7) on intake manifold studs.
4-70
|
