|
| |
TM 10-4320-311-14
Section V. UNIT MAINTENANCE PROCEDURES
INDEX
Para
Page
4-9
Introduction .....................................................................................................................................4-14
4-10
Repair/replace nozzle assembly ......................................................................................................4-15
4-11
Repair/replace suction hose assembly .............................................................................................4-18
4-12
Repair/replace discharge hose assembly .........................................................................................4-19
4-13
Repair/replace Y-connectors and couplings .....................................................................................4-20
4-14
Replace drum suction stub unloader assembly ................................................................................4-21
4-15
Replace ground rod and attaching hardware ....................................................................................4-23
4-16
Inspect/repair/replace sound enclosure cover assembly ..................................................................4-24
4-17
Inspect/replace electrical controls and indicators .............................................................................4-27
4-18
Inspect/repair/replace sound enclosure rear panel assembly ...........................................................4-32
4-19
Inspect/replace front panel and mechanical controls and indicators .................................................4-35
4-20
Inspect/test/replace air intake heater ................................................................................................4-42
4-21
Inspect/replace crankcase oil heater ................................................................................................4-43
4-22
Inspect/replace pump suction and discharge piping, coupling, and fittings .......................................4-45
4-23
Replace/inspect/repair inlet (suction) flange and check valve assembly ..........................................4-47
4-24
Replace/inspect/service volute ........................................................................................................4-49
4-25
Replace/service fuel tank, fuel filter, and fuel cock ..........................................................................4-51
4-26
Replace/service/inspect fuel injection pipe ......................................................................................4-53
4-27
Replace/inspect air cleaner assembly and intake bend ....................................................................4-55
4-28
Replace/inspect exhaust silencer ....................................................................................................4-57
4-29
Replace/inspect/repair recoil starter assembly .................................................................................4-59
4-30
Replace/inspect air Intake baffle, flywheel, and cooling case cover .................................................4-62
4-31
Replace/inspect/adjust valve rocker arm assembly .........................................................................4-64
4-32
Replace/service/inspect lube oil strainer ..........................................................................................4-67
4-33
Replace frame handles ...................................................................................................................4-69
4-34
Inspect/repair/replace storage chests ..............................................................................................4-70
4-9.
Introduction. Maintenance procedures at unit level of maintenance include as necessary: removal, cleaning and
Inspection, repair or replacement, and installation. Unless the procedure requires special resources or tools, more than
one maintenance person, or specific equipment conditions, these are not listed for each maintenance procedure. They
are listed only for those procedures that require them.
4-14
|
