|
| |
TM 10-4320-311-14
g.
Remove dust cap (11) from discharge hose assembly adapter and remove plug (12) from the nozzle assembly
coupler. Connect discharge hose assembly adapter to nozzle assembly coupler or make connections to other
pump accessories as required by desired application. If required, remove cap from nozzle assembly.
NOTE
Use Y-connectors and hoses as needed for multiple nozzle assembly connections.
h.
Make sure that all connections are tight, perform operator PMCS.
2-6. Operating Procedures.
a.
Starting. Refer to Figure 2-4.
CAUTION
The volute must be filled with fluid before starting.
(1) Verify that Preparation For Use procedures listed in paragraph 2-5 and PMCS listed in paragraph 2-3 have
been performed.
(2) Open access door (1).
(3) Set fuel cock (2) to open position by turning handle to the downward position.
Figure 2-4. Starting Procedures
2-19
|
