|
| |
TM 10-4320-311-14
REMOVAL/INSTALLATION:
NOTE
Once the equipment has been prepared to the equipment condition
requirements,
no
further
removal/installation
procedure
is
required.
INSPECTION: Refer to Figure 6-25.
WARNING
When using compressed air, always use chip guards and wear eye
protection.
a.
Clean crankcase with diesel fuel and a wire brush to remove carbon or oil deposits. Wash thoroughly with
live steam and dry with compressed air.
b
Inspect cylinder sleeve for cracks, warpage, corrosion, scoring, or any other damage. Replace crankcase
and piston if damage is found.
NOTE
For piston replacement instructions, refer to para 6-10.
c.
Inspect studs (1 and 2). Replace the studs if damaged
d.
Check that cylinder ID is greater than 2.684 inches (68.16 mm). If the ID is greater than the wear limit,
replace the crankcase.
e.
Inspect studs (3). Replace if studs are damaged.
6-35/(6-36 blank)
|
